Disassembly Procedure - Mitsubishi Electric Mr.SLIM PUHZ-RP35VHA2 Service Manual

15

DISASSEMBLY PROCEDURE

PUHZ-RP35, 50VHA2
OPERATING PROCEDURE
1. Removing the top panel, service panel, front panel and
back panel
(1) Remove the top panel fixing screws (4 × 10), one from
the right and two from the left side, and detach the top
panel.
(2) Remove 1 service panel fixing screw (4 × 10) and detach
the service panel by pulling it downward. (See Photo 2.)
(3) Remove the front panel fixing screws (4 × 10), 5 from the
front, 2 from the right and 2 from the left side, and detach
the front panel.
(4) Remove the back panel fixing screws (4 × 10), 4 from the
right and 3 from the rear side, and detach the back panel.
2. Removing the fan motor
(1) Remove the top panel. (See Photo 1)
(2) Remove the front panel. (See Photo 1)
(3) Remove 1 nut (M6, left-screw) and detach the propeller.
(4) Disconnect the connector CNF1 on the controller circuit
board in the electrical parts box.
(5) Loosen the clamp for the lead wire in the motor support.
(6) Remove 4 fan motor fixing screws (4 × 18) and detach the
fan motor. (See Photo 3)
/VHA3
(1)
Photo 1
Grille
Front panel
Photo 2
Photo 3
Propeller
Nut
Photo 4
Fan motor fixing screws
Fan
motor
(MF1)
Fan motor fixing screws
132
PHOTOS
Top panel
Top panel
fixing screws
Back panel
Service panel
for charge
plug
Service panel
Service panel
fixing screw
Pull down
4 hooks
Electrical parts box
Clamp
Motor support