Mitsubishi Electric Mr.SLIM PUHZ-RP35VHA2 Service Manual page 112

12-1-1. Selecting functions using the wired remote controller
First, try to familiarize yourself with the flow of the function selection procedure. In this section, an example of setting the room
temperature detection position is given.
For actual operations, refer to steps
Mode number
Selecting functions using the wired remote controller
Check the function selection setting.
Switch to function setting mode.
(Press
with the remote controller stopped.)
Specify refrigerant address 00 (outdoor unit)
Specify unit No. 00. (indoor unit)
(Use
Select mode No. 02
(room temperature detection position).
Select setting No. 03 (remote controller fixed).
(Use
End function display.
(Press
to .
Setting number Refrigerant address
and at the same time
and .)
(Specified indoor unit:
Enter the setting.
FAN operation)
(Press .)
and .)
Example:
Enter the setting.
Selecting room temperature
(Press .)
detection position
NO
Finished
YES
and at the same time.)
The above procedure must be carried out only if changes are necessary.
Unit number
For modes 15 and higher,
press and at the same time.
NO
112
Modes 01 to 14 can be activated
by pressing buttons and
simultaneously, and modes 15 to
28 by pressing buttons and
YES
Change refrigerant
address or unit No.
.