Using Your Device In A Vehicle; Using The Car Holder; Connecting The Car Charger - Mio DigiWalker A502 User Manual

1.6

Using Your Device in a Vehicle

Using the Car Holder

Use the car holder to fix your device in a vehicle. (See a separate document
for installation instructions.)
CAUTION:
After the suction cup is secured to the windshield, never try to pull or wriggle the
arm.
When placing the car holder, make sure that the device does not obstruct the
driver's view, or interfere with the operation of vehicle airbags and safety devices.
Always adjust the device and the arm of the car holder for the best viewing angle
BEFORE driving. Avoid adjusting the device with one hand while driving.
When using the car holder, keep the car temperature in a normal range. If the
temperature gets too low, the car holder's suction cup can harden and affect its
suction.
Loosen the locking tab first before removing the car holder.
To retain adhesion of the suction cup, detach and then re-attach the suction cup at
least once a month.
Do not place the device in front of car air heating output.
NOTE: If the car's windshield is tinted with a reflective coating, an external antenna
(optional) may be needed to route the antenna to the top of the car through a window.

Connecting the Car Charger

CAUTION: To protect your device
against sudden surges in current,
connect the car charger only after the
car engine has been started.
The car charger supplies power to the
device. Connect one end of the car
charger to the power connector of the
device and the other end to the
cigarette lighter in the car.
1-14
Getting Started