Using Your Device In A Vehicle; Using The Car Holder - Mio A702 User Manual

1.6

Using Your Device in a Vehicle

Using the Car Holder

Your car holder consists of a bracket and an arm stand. Follow this procedure
to mount the device in a car:
1. Assemble the bracket and the arm stand.
2. Clean the windshield where you will apply the suction cup.
3. Attach the suction cup to the windshield and push in the locking
tab to secure the suction cup.
4. Carefully fit the device into the bracket.
5. Turn the rotate wheel at the top of the arm stand clockwise to loosen
it. Adjust the device to the best viewing angle, and then turn the rotate
wheel counterclockwise to fasten it.
When the device is placed in the bracket, you can push the Volume control
on the bracket to adjust the volume.
CAUTION:
After the suction cup is secured to the windshield, never try to pull or wriggle the
arm.
When placing the car holder, make sure that the device does not obstruct the
driver's view, or interfere with the operation of vehicle airbags and safety devices.
Always adjust the device and the arm of the car holder for the best viewing angle
BEFORE driving. Avoid adjusting the device with one hand while driving.
When using the car holder, keep the car temperature in a normal range. If the
temperature gets too low, the car holder's suction cup can harden and affect its
suction.
Loosen the locking tab first before removing the car holder.
To retain adhesion of the suction cup, detach and then re-attach the suction cup at
least once a month.
Do not place the device in front of car air heating output.
NOTE: If the car's windshield is tinted with a reflective coating, an external antenna
(optional) may be needed to route the antenna to the top of the car through a window.
1-14
Getting Started