Mio DigiWalker A502 User Manual page 122

Item
Tap
Item
7-6
Name
Continuous Sets if you want to take continuous pictures. (See
the "Taking Continuous Pictures" section for
information.)
Storage Sets if you want to save the pictures on the
Location device or SD/MMC card.
Allows you to apply special effects on the
Effect
picture. The options are Normal (default), Sepia
and Mono.
to access the second page:
Name
Shutter Sets the sound when the shutter button is
Sound pressed.
Flicker Sets the flicker frequency to match that of the
Control fluorescent lamp.
GPS Stamp When this function is enabled, you can add the
GPS positioning data into the picture you take.
(See the "Adding the GPS Stamp into the
Picture" section for information.)
Encode Mode Sets the compression mode for picture files.
In the hardware (HW) encode mode, the
program performs faster file compression, uses
less system sources and gives better
performances. After you change to this mode,
you cannot change the mode again until the
device is restored to the factory default state.
In the software (SW) encode mode, the program
will prompt you to change the encode mode
every time you start the camera program. In this
mode, the picture resolution is limited to
400X300 only, and pressing the power button
will close the camera program.
Reset Restores all camera settings (except for the
encode mode) to the default values.
Description
Description
Camera