Disassembly And Assembly - Pride Sundancer User Manual

I X . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. Place the scooter in an area where you have sufficient clearance to move the parts
around. You need about four or five feet in all directions. You may need assistance to lift some of the scooter
components. See IV. “Specifications” for individual component weights.
No tools are required to disassemble or assemble your scooter. Always disassemble or assemble your scooter on
a level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that the
disassembled sections of the scooter take up more floor space than the assembled scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury. Ask for
assistance when necessary while disassembling your scooter.
1. Place the manual freewheel lever in the drive
(up) position.
2. Coil the charger power cord and store it for
future use.
3. Pull up on the seat lock lever and lift the seat
straight up and off the scooter. See figure 12.
4. Gently pull the shroud away from the frame and
lift it off of the scooter. See figure 13.
5. Disconnect the battery straps.
6. Unplug both black and white 2-pin battery
harnesses. See figure 14.
ç
FIGURE 13. REAR SHROUD REMOVAL
30
SEAT LOCK LEVER
FIGURE 12. REMOVING THE SEAT
BATTERY HARNESSES
BATTERY STRAPS
FIGURE 14. BATTERY HARNESSES
Sundancer