Pride Sundancer User Manual page 32

I X . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
1. Place the manual freewheel lever in the drive (up) position.
2. Position the front and rear sections of your scooter as shown in figure 18.
FIGURE 18. FRAME POSITIONING
3. Align the lower slots on the rear of the front section onto the corresponding pegs on the front of the rear
section. See figure 19.
4. Gently lift up on the seat post on the rear section of your scooter, so the rear section pivots into place.
FIGURE 19. CONNECTING THE FRAME HALVES
5. Secure the front and rear sections with the ball detent pin.
6. Raise the tiller
7. Plug the front-to-rear harness into the mating plug found on the rear electronics module.
8. Put the batteries in place and plug the black and white 2-pin battery harnesses into the rear electronics module.
9. Reconnect the battery straps.
10. Gently place the rear shroud over the seat post.
11. Lower the shroud into place.
12. Carefully lift the seat and slide the seat platform (on the seat bottom) onto the seat pedestal.
13. Rotate the seat until it locks into place.
32 Sundancer