Teleco Flat Sat Classic Smart 65 Installation Manual And User's Manual page 15

First switch on the TY2 TV and then the Flat Sat Classic Smart system.
If the Control Panel is in standby press the ON/OFF key (1) to activate it.
When the search has been completed the Display (3) shows the "SAT OK" message; the
antenna is pointed at the selected satellite and the TV shows the set programme.
During the search, after a certain time the "Moving dish" message disappears and the "No
signal" message may appear; this remains on the screen until the satellite is located.
Switching on the Flat Sat Classic Smart
The backlighting comes on and the Display shows the camper
icon with the antenna closed.
Press the ON-OFF key again (1) to
switch on the Flat Sat Classic Smart
system.
The Display (3) alternates the name
of the selected satellite and an
animation of the antenna in search
mode.
The "Moving dish" message
appears on the TV screen to indicate
the antenna is searching for the
satellite
14