Connections - Teleco Flat Sat Classic Smart 65 Installation Manual And User's Manual

Black
Grey
Sat Receiver or
Television with Sat
Receiver
not supplied
Grey
4) The GREEN safety cable of the Control Unit must be
connected to the consensus of the vehicle startup console (in
many cases such consensus is located on Pin 15 in the main
terminal board). In this way, whenever the motor is started,
this cable receives a positive + 12 Vdc voltage, which will
automatically lower the antenna and lock all functions of the
Control Unit simultaneously.
9

Connections

3) Connect directly the BLACK cable of the Control unit to the NEGATIVE
POLE of the vehicle 12 Volt Battery, and the RED cable to the POSITIVE
POLE + (remember not to mix the + and - poles up), using 2 cables of
a cross section of 2.5 mm².
Green
1) Connect the grey cable (motors) to the MOTOR
UNIT connector and the Black coaxial cable
(antenna) to the LNB connector of the Control unit.
2) Connect the Receiver or the TV with Receiver
to the SAT RECEIVER connector. You can connect
any satellite receiver.
The 3-way power connector (P)
must only be inserted in the
12 Vac POWER socket.
Inserting this connector in any
other socket will cause
irreparable damage to the board
and render the warranty null
and void.
WARNING: