Setting Target Heart Rate Zone Limits - Polar Electro Accurex NV User Instruction Manual

9. The last digrt representing single seconds
flashes now. Again, use the SELECT button
to move up, or the SIGNAL/LIGHT button
to move down.
10 When the correct digit
the STORE/LAP button to lock in your
selection.
digit flashes again At this point, you can
access Timer 2 by pressing the SET/START/
STOP button. The phrase TIME 2 WIII appear
on the drsplay. If you wish to program the Timer
2, repeat steps 3. through 10.
12. In case you do not wish to program Timer 2.
simply press t h e S E T / S T A R T / S T O P
button to exrt this function. The LIM function
starts flashing Proceed to step 3 on the next
page to set your personal target heart rate
zone.
Note. As you have set Timer 1 and Timer 2
according to instructions, Timer 1 w/ii start at the
same time you start the stopwatch You wiii hear
one beep when the time of Timer 1 IS up. Timer
2 w//i start automaticaiiy after the beep You w//i
hear two beeps when the time of Timer 2 is up
The timers aiternate untii you stop the stop-
watch.
displayed, press
IS
S T E P - B Y - S T E P
F O R S E T T I N G T A R G E T
R A T E Z O N E L I M I T S
button three times. SET will appear on the
program status line (bottom of the display), and
the display will cycle through automatically
Mode, the latter indrcated either by text SPLI
(splits) or TIME (time of day).
2. At any point, you can press t h e SET/
START/STOP button, and the option LIM will
lock on the drsplay, while the first digit of the
upper heart rate target zone limit starts flashing.
I N S T R U C T I O N S
H E A R T