Usb Devices - Motorola NX-6524 Series Installation Manual

18
Follow the instructions in the current WiNG 5 System Reference Guide for more information on accessing USB
storage devices for file transfers or firmware updates.
To add the NX series platform to the network using the WiNG 5 initial settings wizard, see
Basic Configuration on page

3.2.2 USB Devices

All NX series platforms contain four USB ports for connecting USB flash storage devices to the platform. The
sever can use the USB flash storage device for file transfers and firmware updates. Complete the setup
instructions to connect devices and access the devices through the Web UI or Command Line Interface.
1. Connect the USB flash drive to the USB port on the front of the platform.
2. Set the computer to use an IP address between 192.168.0.10 and 192.168.0.250 on the connected port.
Set a subnet/network mask of 255.255.255.0.
3. Follow the instructions in the current WiNG 5 System Reference Guide for more information on accessing
USB storage devices for file transfers or firmware updates.
22.
NX-4500/NX-6500 Series Intregrated Services Platform