3.2.3 NX Series Expansion Module
The NX Series Expansion Module kit (KT-NXMODC-01) allows for the installation and implementation of up to four
Peripheral Component Interconnect Express (PCIe) cards. The NX Series Expansion Module can be installed in any
of the NX-4500/NX-6500 series platforms.
Total power limit
Total power connector limit
Total PCIe slot power limit
To install the PCIe cards in the expansion module:
1. Remove the expansion module from the packaging.
2. Install the PCIe card into the slot in the expansion module.
3. Connect the power cables to the PCIe card 4 pin connector if required.
4. Install PCIe blanks into any unused slots in the expansion module.
5.95in / 151.1mm
3.16in / 80.4mm
5.39in / 136.9mm
0.80lb / 0.3629kg
3.3VDC @ 3.0A maximum
5.0VDC @ 2.0A maximum
12.0VDC @ 5.0A maximum
NX Series Expansion Module and PCIe cards must be installed by qualified service
Do not install the NX Series Expansion Module when power is applied to the
system. Disconnect the power cord(s) during installation.
Use the half height bracket provided when installing the PCIe cards in an expansion