Download Print this page

Motorola NX-6524 Series Installation Manual Page 25

Integrated services platform.
Hide thumbs

Advertisement

Installation Guide
10. Select an Access Point Type from the following options:
• Virtual Controller AP - When more than one Access Point is deployed, a single Access Point can function
as a Virtual Controller AP. Up to 24 Access Points can be connected to, and managed by, a single Virtual
Controller AP of the same Access Point model. These connected Access Points must be the same model
as the Virtual Controller AP.
• Standalone AP - Select this option to deploy this Access Point as an autonomous fat Access Point. A
Standalone AP isn't managed by a Virtual Controller AP, or adopted by a controller
NOTE
NOTE
11. Select the Country Code of the country where the Access Point is deployed. Selecting a proper country
is a critical task while configuring the Access Point, as it defines the correct channels of operation and
ensures compliance to the regulations of the selected country. This field is only available for the Typical
Setup Wizard.
12. Select Next to set the Access Point's network mode.
If wanting to adopt the Access Point to a controller or service platform,
use the controller or service platform's resident UI to connect to the
Access Point, provision its configuration and administrate the Access
Point's configuration.
If designating the Access Point as a Standalone AP, Motorola Solutions
recommends the Access Point's UI be used exclusively to define its
device configuration, and not the CLI. The CLI provides the ability to
define more than one profile and the UI does not. Consequently, the two
interfaces cannot be used collectively to manage profiles without an
administrator encountering problems.
25
.

Advertisement

   Related Manuals for Motorola NX-6524 Series

This manual also for:

Nx-6500 series, Nx-4524 series, Nx-4500 series

Comments to this Manuals

Symbols: 0
Latest comments: