Resource Reservation Protocol (Rsvp) - Allied Telesis AT-8800 SERIES User Manual

Layer 3
Figure 26: Example output from the SHOW RSVP INTERFACE command.
RSVP Interfaces
Interface Enabled
------------------------------------------------------------------------------
Dynamic No
vlan11 Yes
ppp0 Yes
------------------------------------------------------------------------------
Software Release 2.6.1
C613-02039-00 REV A
Figure 25: Example output from the SHOW APPLE PORT command.
Appletalk Port Details
------------------------------------
Port Number .............. 1
Interface ................ vlan11
ifIndex .................. 1
Node ID .................. 217
Network Number ........... 22
Network Range Start ...... 22
Network Range End ........ 22
State .................... ACTIVE
Seed ..................... NO
Seed Network Start ....... 0
Seed Network End ......... 0
Hint ..................... YES
Hint Node ID ............. 179
Hint Network ............. 22
Default Zone ............. -
Zone List is Empty
------------------------------------

Resource Reservation Protocol (RSVP)

The Resource Reservation Protocol (RSVP) enables the receiver of a traffic flow
to make the resource reservations necessary to ensure that the receiver obtains
the desired QoS for the traffic flow.
RSVP is disabled by default. To enable RSVP, use the command:
ENABLE RSVP
Each IP interface that is to receive and process RSVP messages and accept
reservation requests must be enabled. To enable RSVP on the admin VLAN,
use the command:
ENABLE RSVP INTERFACE=vlan11
To display information about the interfaces enabled for RSVP (Figure 26), use
the command:
SHOW RSVP INTERFACE
Maximum Reserved
Bandwidth(%) Bandwidth(%)
75 0
75 0
75 0
No. Of
Reservations Debug
0 None
1 None
0 None
105
Encap
RAW
RAW
RAW