Installing Or Replacing The Solid-State Drive - Lenovo ThinkStation P300 User Manual

7. Slide the new optical drive into the drive bay until the optical drive snaps into position.
Figure 36. Installing the optical drive
8. Connect any required cables. For the optical drive, connect the power cable and the signal cable to
the rear of the optical drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 123.

Installing or replacing the solid-state drive

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
This section provides instructions on how to install or replace the solid-state drive.
Note: The solid-state drive is only available on some models. For new installation, see "Installing the
solid-state drive" on page 90. For replacement, see "Replacing the solid-state drive" on page 92.
Installing the solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
90
ThinkStation P300 User Guide