Primary Harness Wiring Instructions - Clifford Matrix 2 Installation Manual

Primary Harness Wiring Instructions

This guide describes in detail the connection of each wire. Also included are possible applications
of each wire. This system was designed with the ultimate in flexibility and security in mind. Many
of the wires have more than one possible function. Please read the instructions carefully to ensure a
thorough understanding of this unit and how it operates.
H1/1 ORANGE (-) ground-when-armed output
This wire supplies a (-) ground as long as the system is armed. This output ceases as soon as the
system is disarmed. The orange wire is pre-wired to control the 8618 starter kill relay. It can supply
up to 500 mA of current.
NOTE: If connecting the H1/1 ORANGE wire to control another module, such as a P/N 529T or
P/N 530T window module, a 1 amp diode (type 1N4004) will be required. (See following diagram.)
IMPORTANT! Never interrupt any wire other than the starter wire.
H1/2 WHITE (+/-) selectable light flash output
As shipped, the H1/2 WHITE wire should be connected to the (+) parking light wire. If the light
flash polarity jumper near the main plug is moved to the opposite position (see the Programming
Jumper section of this installation guide), this wire supplies a (-) 200 mA output. This is suitable for
driving (-) light control wires in Toyota, Lexus, BMW, some Mitsubishi, some Mazda, and other
models.
5
www.clifford.com