Clifford Matrix 2 Installation Manual page 17

Hide thumbs Also See for Matrix 2:
Table of Contents

Advertisement

1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in step 1-1, then the system can be
programmed to either lock the doors when passive arming occurs, or only lock the doors when the
system is armed via the transmitter. Active locking means the system will not lock the doors when
it passively arms. Passive locking means that the system will lock the doors when it passively arms.
NOTE: When passive arming is selected, the unit will chirp 20 seconds after the last door is closed.
The system does not actually arm or lock the doors until 30 seconds after the door has been closed.
1-5 PANIC WITH IGNITION ON: This step controls whether or not the Panic Mode is available
with the ignition on. In some states, there are laws prohibiting a siren from sounding in a moving
vehicle. This feature makes the system compliant with these regulations.
1-6 DOOR LOCK PULSE DURATION: Some European vehicles, such as Mercedes-Benz and
Audi, require longer lock and unlock pulses to operate the vacuum pump. Programming the system
to provide 3.5 second pulses, will accommodate the door lock interface in these vehicles. The default
setting is 0.8 second door lock pulses.
1-7 FORCED PASSIVE ARMING ON/OFF: To use this feature, passive arming must be selected in
step 1-1. When turned on, forced passive arming will ensure that the system will passively arm, even
if a zone is left open or invalid. Forced passive arming occurs one hour after the ignition is turned off.
1-8 AUTOMATIC ENGINE DISABLE (AED) ON/OFF: AED is a full-time, passive starter disable
that functions independent of the security system. When turned on the H1/1 ORANGE ground-
when-armed output will activate 30 seconds after the ignition is turned off. The LED will flash at
half its normal rate when the ignition is turned off to indicate that AED is active and will interrupt
the starter in 30 seconds. AED does not occur in Valet mode and can be bypassed using the
emergency override procedure. The transmitter can be used to disarm AED; however, the system
must be armed and then disarmed with the transmitter, in order to disarm AED.
1-9 ARMED WHILE DRIVING/VEHICLE RECOVERY SYSTEM: In the default setting (Armed
While Driving), the system can be armed with the ignition on. When armed, the ground-when-
armed is not active and the sensors are bypassed. The door triggers will remain active. If
programmed to the Vehicle Recovery System (VRS) setting, VRS will be activated.
1-10 ANTI-CODE GRABBING ON/OFF: The system uses a mathematical formula to change its
code each time the transmitter and receiver communicate. This makes the group of bits or "word"
from the transmitter very long. The longer the word is, the easier it is to block its transmission to
the unit. Disabling this feature lets the receiver ignore the Anti-Code Grabbing part of the trans-
mitted word. As a result, the unit may have better range with the Anti-Code Grabbing feature off.
17
www.clifford.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents