M M U U L L T T I I -L L E E V V E E L L S S E E C C U U R R I I T T Y Y A A R R M M I I N N G G; Smart Power Up Ii - Clifford Matrix 2 Installation Manual

Multi-Level Security Arming
Multi-Level Security Arming is only available when using an optional Radar Master transmitter that
has been configured with separate transmitter buttons for arming and disarming. Multi-Level
Security Arming allows you to select which of the system's inputs or sensors will be active or
bypassed at the time that the system is armed. (See Table of Zones section.) Pressing the arm button
again within five seconds of arming the system will activate Multi-Level Security Arming. Each time
the arm button is pressed again, a different security level is selected. The different security levels can
be selected as follows:
➤ ➤
Pressing the arm button once: The siren chirps once. The system is armed.
➤ ➤ Pressing the arm button twice within five seconds: The siren chirps twice followed by a long
chirp. Zone Two is now bypassed.
➤ ➤
Pressing the arm button a third time within five seconds: The siren chirps three times followed
by a long chirp. Zone Four is now bypassed.
➤ ➤ Pressing the arm button a fourth time within five seconds: The siren chirps four times followed
by a long chirp. Zones Two and Four are now bypassed.
➤ ➤
Pressing the arm button a fifth time within five seconds: The siren chirps five times followed by
a long chirp. All input zones, except the ignition, are now bypassed.
NOTE: Multi-Level Security Arming only applies to a single arming cycle. Once the system is
disarmed and then re-armed, all the zones will be active again.

Smart Power Up II

The Smart Power Up II feature ensures that when the security system is powered back up after
power has been disconnected, the system will resume the same state it was in before power was lost.
For example, if power is disconnected during a full trigger sequence, the system will still be in the
full trigger sequence when power is reconnected to the unit. If power is disconnected while the unit
is disarmed, it will still be disarmed when power is restored. This also applies to the VRS sequence.
If the unit loses power at any time during the VRS sequence, it will automatically resume the VRS
full trigger sequence when the unit is powered back up.
www.clifford.com
23