Clifford Matrix 2 Installation Manual page 21

Channels 4-6 (available only when using a Radar Master remote)
Channels 4 through 6 are used to assign the arm, disarm and panic functions to separate buttons
on the remote control. These channels are only available when using an optional Radar Master
remote. (See Transmitter Configurations section of this guide.) Teaching a transmitter button to
Channel 4 erases all previous programming from the transmitter's memory. Similarly, if the trans-
mitter is set up to use the separate arm, disarm and panic channels and a button from that
transmitter is programmed to Channel 1, the transmitter's memory will be erased, and the system
will only recognize the button that was programmed to Channel 1.
Channel 9
If any transmitter button from a known transmitter is programmed to Channel 9, all transmitters
will be erased from memory and will revert to the default feature settings (see the Features Menu
section of this guide). This is useful in cases where the one of the customer's transmitters is lost or
stolen. This will erase any lost or stolen transmitters from the system's memory. It can also be used
to start from scratch if the transmitter buttons were programmed incorrectly.
To advance from one channel to another:
You can advance from programming one channel to another by releasing the Valet/Program switch
and tapping it to advance channels and then HOLDING it. For instance: You have programmed
Channel 1 and you want to program Channel 2. Release the Valet/Program switch. Press it one time
and release it to advance from Channel 1 to Channel 2. Now, press and HOLD the Valet/Program
switch. The LED will flash two times and the siren will chirp twice (if connected). As before, do
not release it.
To exit the learn routine:
One long chirp indicates that Learn Routine has been exited. Learn Routine will be exited if any of
the following occurs:
➤ ➤
Ignition is turned off.
➤ ➤
Door is closed.
➤ ➤ Valet/Program button is pressed too many times.
➤ ➤ More than 15 seconds elapse between steps.
www.clifford.com
21