Table of Contents
Advertisement
for rear clearance before drilling a
-inch hole and mounting the switch.The GRAY wire in the
9
/
32
two-pin plug may also be used as a (+) Ghost switch input and can be connected to any (+) switch
in the vehicle. (See Feature Descriptions section of this guide.)
Programmer Interface, 3-Pin Black Plug
The black three pin port is provided for either a DEI Bitwriter (P/N 998T) or a personal computer
using a PC interface (P/N 996T) to program the unit. When using the Directed Bitwriter or
optional PC Interface Module (P/N 996T) it is possible to configure any or all of the programmable
functions. The PC Interface Module works with an IBM compatible PC. (The 998T does not
require the IBM compatible PC.) For more information please refer to the guide packaged with the
programmer. This port can also be used to interface the Valet Car*Com (Directed P/N 820T) with
the security system.
Shock Sensor Harness, 4-Pin White Plug
RED, BLACK
These wires supply constant 12 volts and ground to the shock sensor. Do not use these wires for
anything except the plug-in shock sensor.
ORANGE (-) Multiplex Input
Inputs shorter than 0.8 seconds will trigger the Warning Zone response, while inputs longer than
0.8 seconds will trigger full alarm sequence and report zone two.
BLUE (-) Multiplex Input
Inputs shorter than 0.8 seconds will trigger the Warning Zone response, while inputs longer than
0.8 seconds will trigger full alarm sequence and report zone four. If installing an optional Directed
dual stage sensor, connect to the blue wire as shown in the following diagram. The following
diagram indicates how to add an optional Directed dual stage sensor to the blue wire (zone 4) and
eliminates the need for diodes to isolate the sensors, as well as providing a separate zone for each
sensor.
11
www.clifford.com
Hide quick links:
Advertisement
Table of Contents
