View Camera Control; System Setup - Kenwood DNX892 Instruction Manual

View Camera Control

( DNX7150BT)
You can set up display when a CMOS-3xx
Series view camera is used.
1
Press the <MENU> button for 1second.
HOME
Camera view screen appears.
2
Adjust each item as follows.
1
1 Guideline
Touching each time turns on or off the
guideline display alternately.
2 Switching the View Camera
Touching each time changes between the
front view camera and rear view camera.
3 Angle
Touching each time changes camera angles in
the following order:
Super wide view/ Wide view/ Overhead view/
Wide view + Top view/ Corner view
For details, see the instruction manual of your
camera.
NOTE
• The video camera controls described above
may not be operable depending the connected
cameras.
• [MENU Key Longer than 1 Second] must be set to
User interface (P.94)
"CAM". See
2 3

System Setup

NOTE
• Each operation in this section can be started from
the multi function menu.
1
Press the
volume knob.
Popup menu appears.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [System].
System Menu screen appears.
See the following section for each setting.
• Set up the user interface
• Adjust touch panel (P.95)
• Set up security (P.96)
• Set up external switch (DNX892,
DNX7150BT only) (P.96)
• Set up memory (P.97)
Return to the Top page
Setting Up
<MENU> button/
(P.94)
93