Customizing Features / Options - Whirlpool WHELJ1 Installation And Operation Manual

Customizing Features / Options

START A CLEAN RINSE CYCLE
To manually start a Clean Rinse cycle, press and
hold the CLEAN button for a few seconds, until
"RECHARGE NOW" flashes in the display.
SET NUMBER OF DAYS BETWEEN
CLEAN RINSE CYCLES
By default the Central Water Filtration System will
automatically initiate a Clean Rinse every 14 days.
This should be sufficient for most applications.
To change the number of days between Clean Rinse
cycles:
1. Press the PROGRAM button twice, so "RECHARGE"
is shown in the display.
s
2. Press the UP or
number of days between Clean Rinse cycles (from 1
to 99).
3. Press the PROGRAM button twice when complete.
SET CLEAN RINSE TIME
By default the Central Water Filtration System will
Clean Rinse at 1:00 a.m.
To change the Clean Rinse start time:
1. Press the PROGRAM button three times, so
"RECHARGE TIME" is shown in the display.
s
2. Press the UP or
Clean Rinse time. Be sure AM or PM is correct.
3. Press the PROGRAM button again when com-
plete.
FIG. 14
FIG. 15
DOWN buttons to set the
FIG. 16
DOWN buttons to set the
SET LENGTH OF CLEAN RINSE
By default the Central Water Filtration System's
Clean Rinse cycle will consist of a 2 minute back-
wash followed by a 1 minute fast rinse. This should
be sufficient for most applications.
Increasing the length of Clean Rinse time will
increase the amount of water flushed to drain during
each Clean Rinse cycle, therefore, these times
should only be increased when necessary.
To change the length of the backwash part of the
Clean Rinse cycle:
1. Press and hold the PROGRAM button for a few
seconds, until the "000--" screen appears, as shown
in Figure 17.
2. Press the PROGRAM button once, so "bA TIME"
appears in the display.
3. Press the UP or
length of backwash in minutes.
4. Press the PROGRAM button twice when complete.
To change the length of the fast rinse part of the
Clean Rinse cycle:
1. Press and hold the PROGRAM button for a few
seconds, until the "000--" screen appears, as shown
in Figure 17.
2. Press the PROGRAM button twice, so "Fr TIME"
appears in the display.
3. Press the UP or
length of fast rinse in minutes.
4. Press the PROGRAM button again when com-
plete.
14
FIG. 17
FIG. 18
s
DOWN buttons to set the
FIG. 19
s
DOWN buttons to set the