Download Print this page

Filtration System Accessories; Flushing The Filtration System; Flow Monitor; Faucet Features (Whab-6014, Whab-6015) - Whirlpool WHAB-6012 Installation Instructions And Use And Care Manual

Ultraease filtration series under sink modular filtration system
Hide thumbs

Advertisement

FILTRATION SYSTEM
ACCESSORIES
Replacement parts
To know your nearest dealer to buy a replacement filter, call
1-866-363-9472 and ask for the part number listed below.
UltraEase™ replacement filter cartridge – Sediment (Unit A):
Part number #WHAB-6009
UltraEase™ replacement filter cartridge – Taste/lead/cyst
(Unit B): Part number #WHAB-6010
UltraEase™ replacement filter cartridge – Chemicals, VOC's
(Unit C): Part number #WHAB-6011
WHAB-6009
WHAB-6010
FLUSHING
THE FITRATION SYSTEM
Before using the filtration system, follow these steps.
1. First make sure the new filters are in place and the water
supply is on.
2. Flush the filters by opening the sink faucet and letting the
water run for approximately 5 minutes. The water will be
dark grey or charcoal colored for a few minutes until the
water is clear.
NOTE: Do not drink water until it runs clear.
12
12. Open the main water line
valve. Check all connections
for leaks.
IMPORTANT:
Before using the filtration
system, follow the flushing
procedure in the "Flushing
Filtration System" section.
WHAB-6011

FLOW MONITOR

The flow monitor indicates when it's time to change your
filters. The green light indicates the filtration is good. The
yellow light indicates the filtration is fair. The red light tells
you it is time to change your filter. You will need to replace
the filter(s) cartridge(s) and the two AA batteries in the flow
monitor (included with replacement filter B, WHAB-6010
and replacement filter C, WHAB-6011).
FAUCET FEATURES
(WHAB-6014, WHAB-6015 models only)

Vegetable sprayer

These two models feature a vegetable sprayer. When needed,
pull down the sprayer to get a mist spray. For a regular flow,
push the sprayer up.
FAUCET CARE
(WHAB-6014, WHAB-6015 models only)

Cleaning

If you have very hard water, and you notice that the water flow
is reduced, it may be necessary to clean the spout screen.
1. Use a small brush and vinegar to remove hard-water deposit.
2. Turn on/off handle to run water briefly to remove vinegar
and deposits from screen.
BEFORE CALLING
FOR SERVICE...
The filter is expected to last 12 months depending on local water
conditions and the volume of water used. We recommend you
change your filter approximately every 12 months, however, it can
be replaced earlier if there is a drop in water pressure at the faucet.
If the faucet does not operate, check these points first:
Has the water supply been turned off?
Check all tubing connections for proper installation.
Make sure filters are intalled properly.

Advertisement

loading

  Related Manuals for Whirlpool WHAB-6012

This manual is also suitable for:

Whaf-0435acWhab-6013Whab-6014Whab-6015Whaf-0335ab