Customizing Features / Options; Start A Clean Rinse Cycle; Set Number Of Days Between Clean Rinse Cycles; Set Clean Rinse Time - Whirlpool WHELJ1 Installation And Operation Manual

Customizing Features / Options

START A CLEAN RINSE CYCLE

To manually start a Clean Rinse cycle, press and hold the CLEAN button
for a few seconds, until "RECHARGE NOW" flashes in the display.
SET NUMBER OF DAYS BETWEEN CLEAN RINSE
CYCLES
By default the Central Water Filtration System will automatically initiate a
Clean Rinse every 14 days. This should be sufficient for most applica-
tions.
To change the number of days between Clean Rinse cycles:
1. Press the PROGRAM button until "RECHARGE" is shown in the dis-
play.
2. Press the UP or
between Clean Rinse cycles (from 1 to 99).
3. Press the PROGRAM button again when complete.

SET CLEAN RINSE TIME

By default the Central Water Filtration System will Clean Rinse at 1:00
a.m.
To change the Clean Rinse start time:
1. Press the PROGRAM button until "RECHARGE TIME" is shown in the
display.
2. Press the UP or
sure AM or PM is correct.
3. Press the PROGRAM button again when complete.

SET LENGTH OF CLEAN RINSE

By default the Central Water Filtration System's Clean Rinse cycle will
consist of a 2 minute backwash followed by a 1 minute fast rinse. This
should be sufficient for most applications.
Increasing the length of Clean Rinse time will increase the amount of
water flushed to drain during each Clean Rinse cycle, therefore, these
times should only be increased when necessary.
To change the length of the backwash part of the Clean Rinse cycle:
1. Press and hold the PROGRAM button for a few seconds, until the
"000--" screen appears, as shown at right.
2. Press the PROGRAM button once, so "bA TIME" appears in the dis-
play.
3. Press the UP or
minutes.
4. Press the PROGRAM button again when complete.
To change the length of the fast rinse part of the Clean Rinse cycle:
1. Press and hold the PROGRAM button for a few seconds, until the
"000--" screen appears, as shown at right.
2. Press the PROGRAM button once, so "Fr TIME" appears in the dis-
play.
3. Press the UP or
minutes.
4. Press the PROGRAM button again when complete.
DOWN buttons to set the number of days
DOWN buttons to set the Clean Rinse time. Be
DOWN buttons to set the length of backwash in
DOWN buttons to set the length of fast rinse in
15
FIG. 15
FIG. 16
FIG. 17
FIG. 18