Whirlpool WHELJ1 Installation And Operation Manual page 7

PLUMBING CODES
All plumbing must be completed in accordance with
national, state and local plumbing codes.
In the state of Massachusetts: The Commonwealth
of Massachusetts plumbing code 248-CMR shall
be adhered to. A licensed plumber shall be used
for this installation.
AIR GAP REQUIREMENTS
A drain is needed for Clean Rinse discharge water. A
floor drain, close to the Central Water Filtration
System, is preferred. A laundry tub, standpipe, etc.
are other drain options. Secure valve drain hose in
place. Leave an air gap of 1-1/2" between the end of
the hose and the drain. This gap is needed to prevent
backflow of sewer water into the Central Water
Filtration System . Do not put the end of the drain
hose into the drain.
Drain
Fitting
Hose
Clamp
Valve
Drain
Hose
Tie or wire
tubing in
place
Drain grate with 1"
dia. hole in center
Installation Requirements
CONNECTING VALVE TO DRAIN
To drain point other
than floor drain.
Support tubing in
place as needed.
Install adaptor
elbow using hose
clamp. Aim noz-
zle down toward
center of drain
FLOOR DRAIN
VALVE DRAIN REQUIREMENTS
Using the flexible drain hose (included), measure and
cut to the length needed. Flexible drain hose is not
allowed in all localities (check your plumbing codes). If
local codes do not allow use of a flexible drain hose, a
rigid valve drain run must be used. Purchase a com-
pression fitting (1/4 NPT x 1/2 in. minimum tube) and
1/2" tubing from your local hardware store. Plumb a
rigid drain as needed (see Figure 4, below).
NOTE: Avoid drain hose runs longer than 30 feet.
Make the valve drain line as short and direct
as possible.
It is recommended that the Central Water Filtration
System be installed near a drain. However, if a drain
is not available, it is still possible to operate the
Central Water Filtration System in a manual Clean
Rinse mode. See "Operating in Manual Clean Rinse
Mode" section. The automatic Clean Rinse function
must be disabled if the Central Water Filtration System
will not be connected to a drain.
SUBSTITUTING RIGID DRAIN LINE
1/4 NPT Threads
Clip
Cut barbs from
drain fitting (pull
clip to remove fit-
ting from valve)
1-1/2"
air gap
1-1/2"
air gap
LAUNDRY TUB
7
Barbs
1/2" Outside Dia.
Copper Tube
(not included)
Comp Fitting. 1/4
NPT x 1/2" O.D.
Tube (not included)
1-1/2"
air gap
STANDPIPE
FIG. 4