Model WHEUFF How to install, operate and maintain your Undersink Full Flow Water Filtration System Do not return unit to store If you have any questions or concerns when installing, operating or maintaining your water filtration system, call our toll free number:...
Before You Start Read all steps and guides carefully before installing and using your undersink full flow water filtration system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all the benefits from the filtration system. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfec- tion before or after the system.
Parts & Tools Included: Filter head, bracket & mounting screws Filter cartridge Tubing Faucet adaptor Not Included: Slotted and Phillips screwdrivers Pliers and adjustable jaw wrench Tubing cutter Electric drill Teflon tape Typical Undersink Installation Locate the water filter housing on the cold water supply pipe, under the kitchen and/or bathroom sink, to filter the cold water.
Installation Instructions Step A - Install Water Supply Fittings Check and comply with local plumbing codes as you plan, then install the fittings to connect the undersink filter into the sink’s cold water supply line. Fittings (9/16-24 thread) and 3/8” O.D. tubing are included to provide connections to and from the undersink filter’s inlet and outlet.
Installation Instructions continued from the previous page Connect Tubing: 1. Use a tube cutter to cut the end of tubing square. 2. Inspect the end (about 1") of the tubing to be sure there are no nicks, scratches or other rough spots. If needed cut the tubing again.
Whirlpool Undersink Full Flow Water Filtration System model WHEUFF with replacement element ® WHEURF conforms to NSF/ANSI 42 and 53 for the specific performance claims as verified and substan- tiated by test data.
Troubleshooting the System Problem: Taste and/or Odor. Cause: Filter cartridge exhausted. Correction: Replace filter cartridge. Cause: System contaminated. Correction: Sanitize system. Call 1-866-986-3223 for instructions. Problem: Water leaks at push connect fittings. Cause: Tubing not pushed in all the way. Correction: Push tubing in all the way into fittings.