Emerson 1F94-80 Operation Manual page 20

Now look at the factory preprogrammed times
and temperatures shown below. If this program
will suit your needs, simply press
running the factory preset program.
FACTORY PREPROGRAMMING
Heating Program for ALL days of the Week:
PERIOD TIME
Occupied (O) 8:00 AM
Unoccupied (U) 5:00 PM
Cooling Program for ALL days of the Week:
PERIOD TIME
Occupied (O) 8:00 AM
Unoccupied (U) 5:00 PM
If you want to change the preprogrammed times
and temperatures, determine the heating and
cooling times and temperatures you want to
use. Use the following table to plan your pro-
20
RUN
to begin
PRGM
TEMP FAN DAMPER
70 PRG Open
64 AUTO Closed
TEMP FAN DAMPER
78 PRG Open
82 AUTO Closed
gram time periods and temperatures. You may
also want to look at the sample program table to
get an idea of how the thermostat can be pro-
grammed. You will select two heating tempera-
tures (HEAT O for occupied temperature and
HEAT U for unoccupied temperature) and two
cooling temperatures (COOL O and COOL U).
NOTE
To operate properly in the AUTO mode, the
highest heat temperature cannot be the same
as or higher than the lowest cool temperature (or
vice versa); see diagram below.
79
COOLING TEMPERATURES
78
77
76
75
HEATING TEMPERATURES
74
DEAD BAND