Emerson 1F94-80 Operation Manual page 16

are too short, press
cycle time. If the heat cycles are too long,
press TIME to decrease the cycle time. To
BACK
set cooling anticipation, press
ADV at the same time again. The display will
DAY
show COOL 14 (factory preprogrammed
cooling anticipation). Use the
buttons to adjust anticipation. Press
return to your program.
• LOW BATTERY INDICATOR — The word
BATTERY will flash on the display if the 9
volt alkaline battery is low and should be
replaced.
16
TIME to increase the
FWD
SET
and
CLOCK
TIME
and TIME
FWD
BACK
RUN to
PRGM
• AUDIO PROMPTING — Each time you
press a button, the thermostat will beep (this
feature works only when the thermostat is
attached to the wall and 24VAC power is
present to the thermostat).
• BACKLIT DISPLAY — When you press
any button on the thermostat, the display is
lit for approximately eight seconds (this fea-
ture works only when the thermostat is
attached to the wall and 24VAC power is
present to the thermostat).
• SYSTEM INDICATOR LIGHTS — The four
lights on the upper right part of the thermo-
stat indicate system operation (see PARTS
OF THE THERMOSTAT).
• COMPRESSOR SHORT CYCLE PROTEC-
TION — To protect your compressor from
potential damage due to rapid cycling, this
thermostat has a built-in delay of 5 minutes