Advertisement
Step 1) Know your Watch:
Push button location:
Push button Main function:
S1 – Start / Lap / Increase adjust (+)
S5 – Stop / Save / Decrease adjust (-)
S11 – Light / Set
Step 2) Charging the Battery:
Charge the unit for at least 4 hours before first use. The length of time for a fully charged battery will last depending on the
actual usage. It is recommended to regularly re-charge your battery every 1-2 months even if it is not used to maintain good
battery condition.
2.1) Plug your USB PC link cable to your PC
2.2) Align the charging clip with the contacts on the back of the Watch.
2.3) Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper electrical contact and prevent
corrosion.
When the battery is low, it is time to charge the watch.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The watch will display LOW BATT. You need to recharge the battery in
order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be saved. Please make sure the
battery have enough battery power before doing your exercise in order not to lose your data.
Step 3) Configure your Watch:
Before using your watch, please set your Watch.
3.1) Go to SET mode and set the following parameters: AUTO LAP, TIME, UNIT, USER, HRM, LINK HRM, NIGHT, Contrast,
CHIME, ALARM, and TIMER.
Getting Started
S3 – View / OK
S7 – Change Mode / Exit
Advertisement
