Problems And Solutions - Excel X-power 10 User Manual

PROBLEMS AND SOLUTIONS

Nature of fault
1. Powerchair does not
drive, and lamp does not
work
2. Powerchair does not
drive, but lamp does work
3. Lamp flashing quickly (2
times per second)
Important
In all cases of an electrical fault, check that the circuit breaker (located on the rear
battery box) is pressed in. If it has been tripped it must be pressed. If the reset
button comes out again, even after the suspected cause of the fault has been
corrected, consult your dealer.
Copyright © 2004 Van Os Medical B.V.
Van Os Medical B.V.
Nijverheidsweg 4-6
Tel. +31 (0) 167 57 3020
Fax +31 (0) 167 57 3381
www.vanosmedical.com
info@vanosmedical.com
Problem
a. Main plug not inserted
b. ON / OFF push button
in OFF position
c. Batteries discharged to
low level
d. Loose plug connection
at controller or battery
a. Drive motor is in
freewheel
b. Fault in controller
electronics
a. Motor plug is loose
b. Battery status is very
low
c. Fault in controller
Action
a. Connect plug properly
b. Push the ON / OFF
button
c. Recharge the batteries
d. Press plugs firmly into
their sockets
a. Reset uncoupling lever
(s)
b. Consult dealer
a. Press plugs firmly
b. Recharge the batteries
c. Consult your dealer
19