Table of Contents
Advertisement
4 Starting
JUMP START
WARNING
Failure to follow the these rules will cause serious injury or death.
BATTERIES PRODUCE EXPLOSIVE GASES.
*Keep sparks, flames, and cigarettes away from battery.
*Do not let tools or other metal touch positive (+) battery post.
*Remove all jewelry, rings, watches, etc.
CONNECT BOOSTER CABLES IN THE FOLLOWING ORDER
*Connect one Positive (+) red end of booster cable to Positive (+) post
on each battery.
*Connect second Negative (-) black end of booster cable to Negative (-)
post of starting battery and the other end to stalled vehicle engine block
or frame.
*Be sure everyone is away from both vehicles.
*Cables must be clear of all moving parts.
*Start engine of starting vehicle. Wait a few minutes.
*Start engine of stalled vehicle.
*If vehicle does not start after cranking for ten seconds, STOP PROCE-
DURE. More than ten seconds seldom starts the engine unless some
mechanical adjustments are made.
*After vehicle starts, remove Negative (-) black booster from engine or
frame ground. Then remove the other end from the starting battery.
*Remove Positive (+) black booster cable from stalled battery, then from
starting battery.
17
Note:
Your unit may be equipped with an automatic tilting device. It is
activated when the transporting vehicle's lights are activated.
6 Transport-EASY HITCH
Install the hitch pins and
attach lynch pins.
Connect the safety chains.
Connect the 7-pin electrical
connector.
Before driving the trans-
port vehicle
Check the function of the
tail, turn and stop lights.
Check the safety chains to
see if they are latched.
Check the hitch and lynch
pins on top of the hooks for
proper installation.
38
Hide quick links:
Advertisement
Table of Contents
