Princeton PIGGY BACK PB50 Operator's Manual page 13

8 Inspection
INSPECTION WITH ENGINE OFF
Do this inspection with the forklift in a safe parked position.
*Warning and safety devices
Push horn button, horn must sound loud and clear. If forklift has other warning
devices (flashing lights, etc..), they must work.
*Frame
Look at the condition of the frame. Report cracked or broken frame members.
*Tires
Check tire pressure. Tires must be inflated to recommended pressure. Inspect
wheel fasteners. All fasteners must be in place and tight. Look at the condition
of the wheels and tires. Report worn, cracked or leaking tires.
*Lift control
Must work freely and return to neutral when released.
*Side shift control
Must work freely and return to neutral when released.
*Carriage control
Must work freely and return to neutral when released.
*Stabilizer control
Must work freely and return to neutral when released.
*Tilt control
Must work freely and return to neutral when released.
*Steering wheel
Must be in good condition and work freely.
*Forks
Must be in good condition and in good alignment. Report any cracks or breaks.
*Fuel system
Inspect fuel lines and fittings for leaks. Do not use open flame to inspect fuel
system.
43
2 Operators Safety Rules and Practices
TRAVELING (cont.)
*Starts, stops, turns and directional changes must be made smoothly to prevent
load shift and overturn.
*No horse play or stunt driving.
LOAD HANDLING
*Only handle loads that are stable, safely arranged, and within forklift capacity.
*Fork length must be within 2/3rds of load length.
*Tilt back only enough to stabilize load.
*Be careful when tilting stacked or high loads.
*Do not tilt forward when elevated except to deposit load.
BEFORE LEAVING OPERATOR'S POSITION
*Bring forklift to a complete stop.
*Do not block the way of fire equipment, fire aisles, or stairways.
*Be sure directional controls are in neutral.
*Full lower forks.
*Set parking brake.
*Turn ignition off and remove key.
ACCIDENTS
*Report all accidents , including personnel, equipment, or building structures.
SLOPES
*Use caution when driving on slopes. Avoid turning on slopes, if possible, and
use extreme caution on grades, ramps or inclines; normally travel straight up
and down.
*Elevation of load should also be avoided on sloped surfaces.
12