Starting - Princeton PIGGY BACK PB50 Operator's Manual

6 Transport-EASY HITCH
Dismounting the PIGGY
BACK from the trans-
port vehicle.
Disconnect the safety
chains.
Disconnect the 7-pin elec-
trical connector.
Remove the lynch pins
and pull out the hitch
pins.
Fasten your seat belt.
Start the PIGGY BACK.
39
BEFORE STARTING be sure
*Forward and reverse control (motion pedal) is in neutral.
*Seat belt is fastened.
*Operator Inspection is done.
COLD START (Deutz)
*Turn key to the right and hold on pre-heat for several seconds.
*Turn the key to the right and start engine.
*When the engine starts release ignition switch.
*If the engine fails to start, turn off ignition switch and repeat the
above.
COLD START (Kubota)
*Turn key to the right and hold on pre-heat for several seconds.
*Pre-heat engine several times in colder climates.
*Turn the key to the right and start engine.
*When the engine starts release ignition switch.
*If the engine fails to start, turn off ignition switch and repeat the
above.
WARM START
*Turn the key to the right and start engine.
*When the engine starts release ignition switch.

4 Starting

16