Princeton PIGGY BACK PB50 Operator's Manual page 11

8 Inspection
*Mast
Push lift control away from you, forks should move down. As the control is
pushed more, the forks should move faster. Report any sticking or jerking.
Pull lift control toward you, forks should move up. As the control is pulled more,
the forks should move faster. Report any sticking or jerking.
Push tilt control away from you, mast should tilt forward. As the control is
pushed more, the mast should tilt faster. Report any sticking or jerking.
Pull tilt control toward you, mast should tilt backward. As the control is pulled
more, the mast should tilt faster. Report any sticking or jerking.
Push carriage control away from you, mast should move forward. As the control
is pushed more, the mast should move faster. Report any sticking or jerking.
Pull carriage control toward you, mast should move backward. As the control is
pulled more, the mast should move faster. Report any sticking or jerking.
Push side shifter control away from you, mast should move left. As the control is
pushed more, the mast should move faster. Report any sticking or jerking.
Pull side shifter control toward you, mast should move right. As the control is
pulled more, the mast should move faster. Report any sticking or jerking.
Push stabilizer control away from you, stabilizer should move down. As the con-
trol is pushed more, the stabilizer should move faster. Report any sticking or
jerking.
Pull stabilizer control toward you, stabilizers should retract. As the control is
pulled more, the stabilizers should move faster. Report any sticking or jerking.
If forklift is unsafe or in need of repair, do not use it until it is returned to a safe
operating condition.
During use, if forklift becomes unsafe in any way, stop using. Do not use it until
is is returned to a safe operating condition.
Do not make repairs or adjustments, unless you are authorized to do so.
DOUBLE REACH (Optional)
1) Ensure the cylinder operates smoothly and that it slows at the end of
extension and retraction.
2) Inspect the cylinder and hoses for leaks and wear.
3) Inspect the bearings for breakage and that they turn freely.
45
LOAD BACKREST
*If the load causes hazard, equip forklift with a vertical load backrest extension.
FUEL
*Fuel handling and storage must be done following ANSI/NFPA 505 and
ANSI/NFPA 30.
HAZARDOUS CONDITIONS
*Operating in hazardous conditions is the responsibility of the user.
AISLES AND OBSTRUCTIONS
*Path of operation and ramps must be marked and clearly visible.
LIGHTS
*Where needed, forklift must have lights.
ENGINE EXHAUST
*Forklift must be used in a well ventilated area.
SOUND
*Consideration should be given to the sound exposure of personnel in the work
area.
DROP OFFS
*Keep safe distance from the edge of ramps and platforms.
TRAILER CREEP
*When driving on and off trucks or trailers apply trailer brakes and chock the
wheels.
*Do not mount or dismount the forklift from a semi-trailer which is not coupled to
a tractor.
*Forklifts mounted to uncoupled semi-trailers may need supports to prevent
upending.
LIFTING PEOPLE
*Do not use this forklift to lift people; it is not designed for it.
*Equipment specifically designed to raise people is available.
OPERATING ENVIRONMENT
*Avoid areas near excavations and embankments.
*Watch out for low electric lines, tree branches, and other obstacles.
SEAT BELT
*Always wear the provided seat belt when operating the forklift.
1 General Safety Rules
10