Kicker LivinLoud SX Series Class D SX1250.1 Owner's Manual page 13

MENU - Here is where you adjust the low pass
Lo-Pass
crossover. Your options are and .
frequency SLOPE
Press the key to enter the
ENT
LO-PASS adjustment menu.
ESC HOME
Use the and keys to
UP DOWN
scroll through frequency and SLOPE
and press the key to select.
ENT
ESC HOME
selects the crossover point and can be set at any
FREQUENCY
1 Hz spaced frequency from 30 Hz to 200 Hz .
Use the UP and DOWN keys to
select your frequency. Press the
to return to the LO-PASS
ESC
ESC HOME
menu.
SLOPE selects the rolloff of the crossover and can be set
from to in 6 dB steps.
oFF 48 dB
Use the UP and DOWN keys to
select your slope. Press the to
ESC
return to the LO-PASS menu.
ESC HOME
NOTE...
While adjusting the low pass crossover you will notice the
indicator on the ISIS VFD display is lit. This indicates
LPF
you are in the LO-PASS crossover menu.
24
SX .1 Series Amplifiers
The KICKER SX amplifier monitors and prevents any low pass
crossover point from being any closer than 1/3 octave from
the high pass crossover point. If you cannot set the low pass
crossover where you want then check the
HPF
see if it is flashing. If it is then you need to go to the HI-PASS
ENT
menu and raise the high pass crossover point.
This is done as a safety precaution to prevent a notch filter
condition.
ENT
ENT
ENT
MENU - Here is where you adjust the high pass
hi-pass
crossover. Your options are
indicator and
Press the ENT key to enter the
LO-PASS adjustment menu.
Use the and
UP DOWN
scroll through frequency
and press the
ENT
FREQUENCY selects the crossover point and can be set at any
1 Hz spaced frequency from
Use the and
UP DOWN
select your frequency. Press the
key to return to the HI-PASS menu.
selects the rolloff of the crossover and can be set
SLOPE
from OFF to 24 dB
Use the UP and DOWN
select your slope. Press the
to return to the HI-PASS menu.
NOTE...
While adjusting the high pass crossover you will
indicator on the ISIS VFD display is
notice the hpf
lit. This indicates you are in the HI-PASS crossover menu.
The KICKER SX amplifier monitors and prevents any high
pass crossover point from being any closer than 1/3 octave
frequency and SLOPE .
from the low pass crossover point. If you cannot set the high
pass crossover where you want then check the
and see if it is flashing. If it is then you need to go to the
ESC HOME ENT
LO-PASS menu and lower the low pass crossover point.
This is done as a safety precaution to prevent a notch
keys to
filter condition.
and SLOPE
key to select.
ESC HOME ENT
to z.
10 Hz 60 H
keys to
ESC
ESC HOME ENT
in 6 dB steps.
keys to
ESC
ESC HOME ENT
SX .1 Series Amplifiers
LPF indicator
25