Washable Front Panel; Removing The Front Panel; Attaching The Front Panel - Hitachi RAS-25CNH1 Service Manual

2.

Washable Front Panel

Remove the front panel and wash with clean
water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly
with clean water.
When front panel is not removed, wipe it with
a soft dry cloth. Wipe the remote controller
thoroughly with a soft dry cloth.
Wipe the water thoroughly.
If water remains at indicators or signal
receiver of indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands
to detach and attach it.

Removing the Front Panel

When the front panel is fully opened with
both hands, push the right arm to the inside
to release it, and while closing the front panel
slightly, put it out forward.
CAUTION
!
Do not splash or direct water to the body of the unit when cleaning
it as this may cause short circuit.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or
a brush, because they will damage the plastic surface and the coating.
Arm
Move the projections of the left and right
arms into the Flanges in the unit and
securely insert them into the holes.
– 26 –

Attaching the Front Panel

Flange
Projection
Hole