How to check Power module
Checking power module using tester
Set tester to resistance range(x100).
If indicator does not swing in the following conductivity check, the power module is normal.
_
(In case of digital tester, since built-in battery is set in reverse direction, +
and
terminals are reversed.)
CAUTION
!
If inner circuit of power module is disconnected (open), the indicator of tester will not swing and this may assumed as
and _
normal. In this case, if indicator swings when +
terminals are connected in reverse of diagram below, it is
normal. Furthermore, compare how indicator swings at U, V and W phases. If indicator swings the same way at each
point, it is normal.
– 111 –