Cleaning Of Front Panel; Wiring Arrangement - Hitachi air Home 400 DJ Series Operation Manual

2.

CLEANING OF FRONT PANEL

Remove the front panel and wash with clean water.
●
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with clean water.
When front panel is not removed, wipe it with a soft dry cloth.
●
Wipe the remote controller thoroughly with a soft dry cloth.
Wipe the water thoroughly.
●
If water remains at indicators or signal receiver of indoor unit,
it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to detach and
attach it.
Removing the Front Panel
Move
When the front panel is fully opened with both
●
hands, push the right arm to the outside to release
it, and while closing the front panel slightly, pull it
out forward.
●
!
CAUTION

WIRING ARRANGEMENT

CAUTION
!
Please use earth line.
●
Do not place the earth line near water or gas pipes, lightning-conductor, or the earth line of
telephone. Improper installation of earth line may cause electric shock
A circuit breaker should be installed depending on the mounting site of the unit. Without a circuit breaker,
●
the danger of electric shock exists.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow
Blue
Brown
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
NOTE
If the supply cord is damaged, it must be replaced by the special cord obtainable at authorized service/parts
centers.
Cleaning and maintenance must be carried out only by qualifi ed service personnel. Before
CAUTION
!
cleaning, stop operation and switch off the power supply.
Arm
Push
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because they will damage the plastic surface and the coating.
: Earth
: Neutral
: Live
or coloured green or green-and-yellow.
Attaching the Front Panel
Insert
Move the projections of the left and right arms into
●
the Flanges in the unit and securely insert them
into the holes.
– 10 –
Arm
Shaft
Insert
Step