CHECKING THE REFRIGERATING CYCLE
1. Troubleshooting procedure (No operation, No heating, No cooling)
Connect U,V,W phase leads to the
power module again and operate
the air conditioner.
Is the self-diagnosis lamp mode as
shown on the right?
Stop to operate and check the gas
pressure in balancing mode.
Gas leaks.
Repair and seal refrigerant.
YES
Normal
(0.39-0.98MPaG)
(4-10kg/cm
Gas leakage
(Less than 0.39MPaG)
2
(Less than 4kg/cm
G)
Perform a final check of operation.
(JUDGING BETWEEN GAS LEAKAGE AND
COMPRESSOR DEFECTIVE)
Lighting mode
Blinks
Self-
2 times
diagnosis lamp
RAC-163CNHZ
LD301
LD302
Time until the
lamp lights
Possible
malfunctioning
part
2
G)
The compressor is defective. Replace it and
seal refrigerant.
If the compressor checker for an
inverter type air conditioner is
available, re-check using it.
– 112 –
Blinks
Blinks
Blinks
Blinks
3 times
4 times
5 times
6 times
Within
Approx.
approx.
2-3 seconds
10
30
seconds
minutes
Gas
Compressor
leakage
Blinking
Lit
When the
self-diagnosis lamp
lights in the same
condition as above.
Blinks
8 times
Approx.
10
seconds
Compressor