Table of Contents
Advertisement
Installation
Removing and Installing the
Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in
the door. You may need to use a flat screwdriver to pull the door
surround outwards. (See figure 8a).
Slot 'A'
Magnet
Pull bottom of door
surround outwards
and upwards.
Figure 8a. Removing door surround.
Removing the door:
To install/remove the glass door simply attach/remove the four (4)
machine screws, align tabs at the bottom of the door with the slots in
the bottom door rail (See figure 8b). Ensure that a good seal is
maintained.
Machine Screws
Door Rail
Figure 8b. Installing Glass Door.
XG0400 05/00
Tab 'B'
Door surround
Glass door
and frame
Tabs
M38BV-ST B-Vented Fireplace
Operation
Lighting Instructions
See Pages 8-9.
Burner Adjustment
The M38BV-ST is equipped with an adjustable burner, allowing you to
raise or lower the flames. To adjust the flames, locate the black knob
marked 'Hi-Lo', in the centre of the gas control valve (See Figure 26).
The front burners are not adjustable.
n
To raise the flame height, turn the black knob (located behind the
lower trim) counterclockwise.
n
To lower the flame height, turn clockwise.
Figure 9. 'Hi-Lo' Adjustment on the M38BV-ST gas valve.
Note: M38BV-ST models (electronic ignition) do not feature
hi/lo adjustment.
Page 7
Advertisement
Table of Contents
