Power Supply Connection - Oce CS 4040 Installation Manual

Power supply connection

The Océ CS 4040/4050 use a grounded 3-prong power cord to connect to a
grounded power outlet with a maximum 16-ampere protection.
Your electrical installation must comply with IEC 364 standards and the
national standards of your country.
To connect the scanner to the power supply
Locate the power connector at the back of your scanner.
1
Plug one end of the power cord delivered with the scanner into the connector.
2
Verify that the inlet voltage selector setting corresponds to the voltage of your
3
electrical outlet.
Plug the other end of the cord into the electrical outlet.
4
Turn the
5
The warm-up indicator on the scanner control panel lights up and remains lit
while the scanner performs various internal diagnostic tests. When fully
powered on, the Power-on indicator stays lit continuously.
Scanner installation
switch to
ON/OFF ON
.
17