Error Codes - Bodyguard T240 Owner's Manual

Error Codes

Table 3
PROBLEM
• Acceleration is too quick in an acceleration or reached speed phase.
• Error 1
• Possible causes: Motor drive defective or user pushing on the running belt for too long.
• Running belt not following the speed required in the reached speed phase.
• Error 2
• Possible causes: Deck too sticky. Walk on deck for 15 minutes at 4 mph.
• Motor drive board can be defective.
• Check speed sensor or optical disk.
• Acceleration is too fast during acceleration phase.
• Error 11
• Possible cause: Defective drive board.
• Acceleration is too slow during acceleration phase.
• Error 12
• Possible causes: Deck too sticky.
• Walk on deck for 15 minutes at 4 mph.
• Speed sensor problem.
• In a deceleration phase, the speed slows too fast.
• Error 21
• Possible cause: Drive board defective.
• In a deceleration mode, the speed slows down too slowly.
• Error 22
• Possible cause: Drive board defective, speed sensor problem.
• There is an abnormal acceleration during deceleration.
• Error 23
• Motor drive board is defective.
• Acceleration is too quick under 2 mph.
• Possible causes: Motor drive defective or user pushing on the running belt for too long.
• Error 31
• Elevation motor values from potentiometer are out of range.
• Possible causes: Elevation motor is defective or uncalibrated.
• Perform an elevation calibration in the diagnostics menu.
• Motor drive boa rd can be defective.
• Elevation Motor not functionnal.
• Elevation
• Elevation Motor not connected.
Motor
Error
Thank You for Purchasing a Bodyguard
Bodyguard ® Fitness is dedicated to designing and manufacturing the finest fitness equipment available today.
This manual outlines information on warranty, assembly, operation of the unit, safety and basic maintenance checks for the
Bodyguard ® T240 – T260 treadmills.
When you require service for your T240 – T260, always present the unit product model, serial number and date of purchase
to the Bodyguard ® Dealer. The product model and serial numbers are located at the front of the machine. Now is a good
time to write the product model and serial numbers and related information in the space provided.
30
CAUSE / SOLUTION
® T240 – T260