Keys Fitness Strength Trainer ST-PT Owner's Manual page 4

Step 2
1. Insert one Ø 25 Long Foam Grip (No. 16) onto the middle of the Pull-up Bar (No. 18), then
insert the Ø 25 mid Foam Grips (No. 15) onto each ends of the Pull-up Bar (No. 18). slide the
Connective Heads (No.17) onto both ends of Upper Upright Tube (No. 11),
2. Connect the Pull-up Bar (No. 18) to the both ends of Upper Upright Tube (No. 11), secure
them with two M10 x 55 Bolts (No. A3) and two Ø10 Washers (No. B1).
3. Connect two Upper Upright Tubes (No. 11) to the Lower Upright Tubes (No. 6), secure them
with four M10 x 20 Bolts (No.A1) and four Ø10 Washers (No. B1).
4. Insert four Ø 25 Short Foam Grips (No. 3) into each handle of the two Extend Arms (No. 13).
5. Attach the two Extend Arms (No. 13) through the joints of Upper and Lower Upright Tubes
(No. 11 & No. 6) to the Upper Cross Brace (No. 12), secure them with four M10 x20 Bolts
(No. A1), two M10x70 Bolts (No.A2), eight Ø10 Washers (No. B1) and two M10 Aircraft Nuts
(No. C1).
6. Connect the two Upper Support Bars (No. 14) to both the Extend Arms (No. 13) and Lower
Upright Tubes (No. 6), secure them by four M10 x 70 Bolts (No. A2), eight Ø10 Washers (No.
B1) and four M10 Aircraft Nuts (No. C1).
4