Check The Print Quality - Brother DCP-6690CW Quick Setup Manual

h
Gently push the ink cartridge until it clicks. After
all the ink cartridges are installed close the ink
cartridge cover.
Note
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
6

Check the print quality

Important
Make sure you put paper in the upper tray for
the initial setup.
a
When the preparation process has finished, the
LCD shows this message
.
Set Paper and Press Start
Press Colour Start.
b
Check the quality of the four colour blocks
on the sheet. (black/yellow/cyan/magenta)
c
If all lines are clear and visible, press Yes to
finish the quality check.
<Black>
OK
If you can see missing short lines, press No and
go to d.
<Black>
Poor
d
The LCD asks you if the print quality is OK for
black and colour. Press Yes or No.
After pressing Yes or No for both black and
colour, the LCD shows:
e
Press Colour Start, the machine will then start
cleaning the colours.
f
After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again. Go back to b.
a
1 1
<Colour>
<Colour>
Black OK?
Yes No
Start Cleaning?
Press Start
OK
Poor
5