Brother DCP-6690CW Quick Setup Manual page 20

Wired Network
For Wired Network Interface Users (For Mac OS
10
Before you install
a
Make sure your machine is connected to the
power and your Macintosh
be logged on with Administrator rights.
Important
®
• For Mac OS X 10.2.0 to 10.2.3 users,
upgrade to Mac OS
the latest information for Mac OS
http://solutions.brother.com/)
• Make sure there are no memory cards or a
USB Flash memory drive inserted.
• If you have previously set up your machine
for a wireless network and then want to set
it up on a wired network, you should check
that the machine's Network I/F is set to
Wired LAN. The wireless network interface
will be inactive with this setting. On your
machine, press MENU.
Press a or b to display Network and press
Network.
Press Network I/F.
Press Wired LAN.
Press Stop/Exit.
11
Connect the network
cable
a
Lift the scanner cover into the open position.
20
®
is ON. You must
®
X 10.2.4 or greater. (For
®
X, visit
Macintosh
®
X 10.2.4 or greater)
b
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
c
Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your network.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used,
guide both cables through the trench with one on
top of the other.
®
symbol. You will find the