Hardware Monitoring - Supero SUPERSERVER 5015B-M3 User Manual

S S
UPER ERVER 5015B-M3 User's Manual
Console Connection
This item allows you to decide how console redirection is to be connected: either
Direct or Via Modem.
Continue CR after POST
Select on to continue with console redirection after the POST routine. The options
are On and Off.

Hardware Monitoring

Highlight an item and hit <Enter> to see the status of the item:
CPU Temperature/TControl/CPU1 Temperature/System Temperature
Fan1 - Fan 6
If the feature of Auto Fan Control is enabled, the BIOS will automatically display
the status of the fan as specifi ed.
Fan Speed Control Modes
This feature allows the user to decide how the system controls the speeds of the
onboard fans. The CPU temperature and the fan speed are correlative. When
the CPU on-die temperature increases, the fan speed will also increase, and vice
versa. Select Workstation if your system is used as a Workstation. Select Server
if your system is used as a Server. Select 3-pin if your chassis uses 3-pin fans.
Select 4-pin if your chassis uses 4-pin fans. Select "Disable" to disable the fan
speed control function and allow the onboard fans to constantly run at the full
speed (12V). The Options are: 1. Full Speed @12V, 2. Optimized Server w/3-pin,
3. Optimized Workstation w/3-pin, 4. Optimized Server w/4-pin, and 5. Optimized
Workstation w/4-pin.
Voltage Monitoring
The following items will be monitored and displayed:
VcoreA, -12V/+12V, V_DIMM, +3.3V/+3.3Vsb, Vbatt.
Note: In the Windows OS environment, the Supero Doctor III settings take prece-
dence over the BIOS settings. When fi rst installed, Supero Doctor III adopts the
temperature threshold settings previously set in the BIOS. Any subsequent changes
to these thresholds must be made within Supero Doctor, since the SD III settings
override the BIOS settings. For the Windows OS to adopt the BIOS temperature
threshold settings, please change the SDIII settings to be the same as those set
in the BIOS.
7-16