Planet IGSW-2840 User Manual page 470

mac-authentication max-mac-count
Use this command to set the maximum number of MAC addresses that can be authenticated on a port via 802.1X authentication
or MAC authentication. Use the no form of this command to restore the default.
Syntax
mac-authentication max-mac-count count no mac-authentication max-mac-count
count - The maximum number of 802.1X and MAC-authenticated MAC addresses allowed. (Range: 1-1024)
Default Setting
1024
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
network-access dynamic-vlan
Use this command to enable dynamic VLAN assignment for an authenticated port. Use the no form to disable dynamic VLAN
assignment.
Syntax
[no] network-access dynamic-vlan
Default Setting
Enabled
Command Mode
Interface Configuration
Command Usage
When enabled, the VLAN identifiers returned by the RADIUS server will be applied to the port, providing the VLANs have
already been created on the switch. GVRP is not used to create the VLANs.
The VLAN settings specified by the first authenticated MAC address are implemented for a port. Other authenticated MAC
addresses on the port must have same VLAN configuration, or they are treated as an authentication failure.
If dynamic VLAN assignment is enabled on a port and the RADIUS server returns no VLAN configuration, the
authentication is still treated as a success, and the host assigned to the default untagged VLAN.
When the dynamic VLAN assignment status is changed on a port, all authenticated addresses are cleared from the
secure MAC address table.
470
User's Manual of IGSW-2840