Motion Detection - Honeywell HD251(X) Configuration Manual

Motion Detection

1. When the SPECIAL menu is displayed, use the Up or Down OSD controls to access
the MOTION DETECTION menu (see
Figure 25
SPECIAL
CAMERA TITLE OFF

ADJUST
MIRROR

MOTION DET
PRIVACY
SYNC
RESOLUTION
RESET

RETURN
2. Configure the Motion Detection settings (see
ALARM Options are ON and OFF. Select whether motion will activate a visible onscreen
alarm.
AREA ON The area(s) that will be monitored for motion can be set by changing the TOP,
BOTTOM, LEFT and RIGHT values.
a. Select AREA in the MOTION DET menu and press SET to open the MOTION
AREA menu (see
b. In this menu, select the motion detection area to be adjusted (from AREA1 to
AREA4) and press SET to open the AREA1~4 menu.
c. Use the Up, Down, Left and Right OSD controls to change the TOP,
BOTTOM, LEFT and RIGHT values, as needed.
d. Select RETURN and press SET to save the area.
Figure 26
MOTION AREA

AREA1
AREA2
AREA3
AREA4

RETURN
SPECIAL Menu - MOTION DETECTION Submenu Selection
OFF
OFF
OFF
INT
NORMAL
NO
Figure 26).
MOTION DETECTION AREA Adjustment
ON
ON
ON
ON
Configuring the Camera | 23
Figure 25).
MOTION DET

ALARM

AREA
SENSITIVITY
DISPLAY
HOLD TIME

RETURN
Figure 25) as follows:
AREA1~4 ON

TOP
BOTTOM
LEFT
RIGHT

RETURN
ON

025
OFF

003

25

65

30

80
800-12004V2 - A - 01/2013