Day / Night - Honeywell HD251(X) Configuration Manual

Day / Night

Picture can be displayed in either color or black and white.
1. Select DAY / NIGHT using the Up or Down OSD controls on the SETUP menu
screen (see
2. Select the desired Day/Night mode (COLOR, BW, EXT, or AUTO) using the Left and
Right OSD controls.
Figure 15
COLOR The picture is always displayed in color.
BW The picture is always displayed in black and white. Select BW using the Left and Right
OSD controls and open the menu to activate BURST option.
EXT Day/Night control performed by photocell on the camera board (see
option is NOT supported by the HD251(X) camera. Only the HD262(X) and HB273(X)
cameras may use this option.
Figure 16
AUTO In this mode, the camera automatically switches to COLOR in normal conditions
and switch to BW mode when ambient illumination is low. This option is NOT supported by
the HB273(X) and HD262(X) cameras. Only the HD251(X) camera may use this option.
Press SET to set the switching time or Day>Night(AGC), Night>Day(AGC) in AUTO mode.
Figure 15).
MAIN SETUP Menu - DAY/NIGHT Selected
MAIN SETUP
LENS

EXPOSURE
WHITE BAL
D-WDR/HSBLC
HD-DNR

DAY/NIGHT
SMART-IR

SPECIAL

EXIT
Day/Night EXT Menu
D&N-EXT

BURST
DELAY TIME

RETURN

DC
ATW
OFF
AUTO
COLOR

OFF
OFF

4
Configuring the Camera | 17
Figure 16). This
800-12004V2 - A - 01/2013