Call Screening; Number Of Rings - AT&T CL82113 Complete User's Manual

Answering system
Answering system settings

Call screening

Use this feature to choose whether incoming messages can be heard over
the speaker when they are being recorded. If you turn call screening on, you
hear the incoming message. While monitoring an incoming message, you can
answer the call by pressing
To change the setting:
1. When the handset is in idle mode, press MENU/
to enter the main menu.
2. Press q or p
CID
press /SELECT.
MENU
3. Press q or p
CID
press /SELECT.
MENU
4. Press /SELECT to select Call screening.
MENU
5. Press q or p
CID
/SELECT to save the setting. You hear a
6. Press
MENU
confirmation tone.
NOTE: For more information on call screening, see page 64.

Number of rings

You can set the answering system to answer an incoming call after two, three,
four, five or six rings. You can also select toll saver. If toll saver is selected, the
answering system answers a call after two rings when you have new messages,
and after four rings when there are no new messages. This feature allows you
to check for new messages and avoid paying long distance charges when
calling from out of your local area. By default, the answering system answers
an incoming call after four rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/
menu.
2. Press q or p
CID
3. Press q or p
CID
PHONE/
to scroll to Answering sys, then
DIR
to scroll to Ans sys setup, then
DIR
to choose On or Off.
DIR
to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
DIR
on the handset.
FLASH
SELECT
SELECT
58
Answer ON/OFF
>Ans sys setup
Call screening
>
# of rings
CALL SCREENING
>On
to enter the main
/SELECT.
MENU
/SELECT.
MENU